Maximum Speed: 200000 rpm. Maximum Frequency: 3408 rpm. Maximum Drilling Size: 6.35 mm. Bearing Pressure: 5.5-6.5 kg/cm2. Maximum Axial Load: 200 N. Maximum Radial Load: 90 N. Rated Coolant Flow: 1.2-2 L/min.
Normal 0 false false false EN-US X-NONE X-NONE MicrosoftInternetExplorer4 BALDOR TAPERED SPINDLE 3/8″ RIGHT Fits Baldor POLISHING LATHE TAPERED SPINDLE FITS BALDOR DENTAL LATHE MOTORS The spindle is made to use with a Baldor Dental Polishing motor. Spindle is fits 3/8″ Polishing lathes has an inside diameter that is tapered to fit on the tapered shaft of a Baldor Dental Polishing motor. These are specifically made to fit Baldor motor shafts since they are not straight, but have a slight taper. Spindles are a friction fit, they are pushed on to the shaft of the Baldor motor, to properly secure them onto the shaft, lightly tap with a soft mallet or a piece of wood. To remove, just use the screw off spindle remover on the motor by simply unscrewing and turning it until the spindle is pushed off of the tapered shaft. . Spindles is made of cold rolled steel is machined to close tolerances, made in U.S.A. . Spindle has a 3/8″ Tapered arbor hole to work on the RIGHT Side of Baldor 3/8″ shaft motors. The spindle arbor hole has a slight tapered to fit and be held on the Baldor Motor Lathes RIGHT Side shaft. Note: Spindle does not have tightening screws. . FEATURES: · Precision Quality · Machined – High Speed Lathe · Made from 3/4″ Stock Material SPECIFICATIONS: JETS Product # 1603-112370 · Material: Cold Rolled Steel · Overall Length: 3-1/2″ – 90mm · Spindle Body Length: 1-3/8″ – 35mm · Spindle Tapered Length: 2″ – 51mm · Arbor Hole: 3/8″ Tapered Friction Grip to Shaft · Weight: 2.75oz. Spindle is made to be used on a 3/8″ tapered shaft diameter and on the Right Hand Side of Motor with forward direction. SHIPPING: Via USPS FIRST CLASS MAIL NOTE: Visit JETS INC. our ebay Store where you can see listings of various Commercial Grades of Spindles, Arbors, Miniature Mandrels and Holders along with more Jewelers Equipment Tools and Supplies. JETS Inc. B4 613 CKSP M
The spindle is made to use with a Baldor Dental Polishing motor. These are specifically made to fit Baldor motor shafts since they are not straight, but have a slight taper. Spindles are a friction fit, they are pushed on to the shaft of the Baldor motor, to properly secure them onto the shaft, lightly tap with a soft mallet or a piece of wood.